Memorex MLT1912 Computer Monitor User Manual


 
REMOTE CONTROL
7
BATTERY INSTALLATION
AA
AA
AAA
AAA
1
1.
Remove the Battery Compartment cover by pushing in on the tab and lifting the cover off.
2. Install two (2) “AA” batteries (not included), paying attention to the polarity diagram in the Battery Compartment.
3. Replace the Battery Compartment cover.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed
batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old batteries with
fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer’s directions.)
FAQs:
Why is the remote control not working properly?
The remote control is not aimed at the sensor.
The remote control is too far away from the remote sensor.
There is too much light in the room.
There is an obstacle in the path of the beam.
The batteries are weak or dead.
The batteries are inserted incorrectly.
The TV is not plugged in.
EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER
30°
20 ft
30°
NOTES:
When there is an obstacle between the TV and the
transmitter, the transmitter may not operate.
When direct sunlight, incandescent lamp, fluorescent
lamp or any other strong light shines on the REMOTE
SENSOR of the
TV
, the remote operation may
be unstable.
123