Filter
Top Products
Section 4: BIOS Setup Utility
M54E2 System Board Manual
The BIOS Setup Utility
Configuration
After the M54E2 system board and all hardware is installed, the system
is ready for configuration. Before turning on the computer, make sure
all cables are correctly connected and all jumpers are correctly set.
It is recommended you keep the computer cover off the first time you
boot the system. If you have any difficulties, they will be easier to
correct.
Initial Boot Up
Power up the M54E2. If the system doesn’t properly boot, check all
your cables and peripherals for bad connections. You may also get beep
codes or error messages. If this occurs, consult Appendices A and/or B
for a guide to possible solutions.
After the system properly boots, it is ready to be configured. The
following pages explain the proper procedures for BIOS configuration.
4-1
4