Filter
Top Products
Section 4: BIOS Setup Utility
M54E2 System Board Manual
Figure 4-5: Boot Options Submenu
Boot Sequence
This category selects the order the system searches for a boot disk and can be
set for: A: then C:
C: then A:
C: only
Swap Floppies
This category can be set to remap the floppy drives. It can be set for
NORMAL (default) or SWAPPED. For normal operation, Drive A: and
Drive B: work normally. When “Swapped” is selected, Drive A: becomes
Drive B:, and Drive B: becomes Drive A:.
Floppy Check
When enabled, this category verifies the floppy drive is installed on boot. For
faster booting, select DISABLED (default).
SETUP Prompt
When enabled, this category allows the system to display the “Press <F2> to
enter SETUP” message during boot.
4-8