Filter
Top Products
Video signals. If the video source has a Component Video jack, it can be
connected to transmit video signals to the projector.
Note: The projector is not compatible with a cable TV-style F connector.
A connection can be made to all Component Video, S-Video and composite video
sources at the same time. To select a signal source, you may use the Video key
on the remote control or the Source key on the projector for your selection.
Cables can be connected to the Component Video, S-Video and the Composite
Video connectors at the same time. Press the above said Video key or the Source
key for the selection of an input signal. The selections in order are the following:
First, the Component Video signal, then the S-Video signal, and the Composite
Video signal is the next.
The projector supports NTSC, PAL and SECAM video formats. By default, it
automatically detects and identifies the video format.
The steps of connecting the projector to the video source
1. Shut off the projector and its video source if they are on.
2. To receive composite video signal, connect the yellow RCA plug at one end
of the RCA Cable (Video) to the Video In jack of the projector. Connect the
other yellow RCA plug to the video-out jack on the video source. (Connect
the red and white
RCA Cable (Audio) plugs, which carry audio signals, to the
projector and any video player according to the aforesaid method. If the red
and white
RCA Cable (Audio) plugs are not connected, the projector will only
show images. No sound will be heard.)
18