Filter
Top Products
C.1 Accessing the HTTP Server Screens
C-4
Using a Web Browser
Appendix C
Note
Important!
C.1.2.1 Reset
Use this screen when you need to reset the NIC to allow newly set
parameter values to take effect.
Note that resetting the NIC fully initializes the network interface,
without initializing the interface with the printer.
C.1.2.2 Factory Defaults
Use this screen when you need to restore the factory defaults when
you move the NIC to a new location or to clear incorrect settings.
Note
C.1.2.3 Unit Status
This screen shows the status of each protocol. You can jump directly
to the section of the page for a specific protocol by clicking on the
applicable protocol link.
C.1.2.4 Network Address
The serial number of the unit as well as the MAC Address can be
confirmed from this screen.
• You need Supervisor or Administrator privileges to have full use of
Web browser capabilities. The factory default management password
is: “
sysadm
”.
• To change network settings you must first type the correct password
(same as the management password) in the password field provided.
• Clicking a button to execute a network setting change operation while
the wrong password is in the password field causes the password error
screen to appear, without changing the setting.
• Settings made will not be recognized by the printer until the power to
the printer is turned off and then on again.
PageWorks.book Page 4 Tuesday, August 4, 1998 11:21 AM