Filter
Top Products
5
INSTALLATION PLACEMENT
Install the UPS in a temperature controlled environment that is free of conductive contami-
nants. Select a location which will provide good air circulation for the UPS at all times. Avoid
locations near heating devices, water or excessive humidity, or where the UPS is exposed
to direct sunlight. Route power cords so they cannot be walked on or damaged.
The site wiring fault LED illuminates when the UPS detects an improperly wired AC power
outlet (120 vac MODELS ONLY) see section 3.
The output power receptacles are NEMA 5-15R type. (IEC output sockets on 230 VAC
models)
The input power cord has a NEMA 5-15P connector. (IEC input socket on 230 VAC models)
The input circuit breaker will trip in the event the load exceeds the UPSs power rating.
The RJ-45/RJ-11 modular connectors are used for 10 Base-T network/single line telephone
surge protection (see section 3).
The computer interface port is for UPS monitoring and control (see section 3).
REAR PANEL (120 vac models shown)
Pro 1400 rear panel
In
Out
3
INSTALLATION
Interface Port
SWF
Circuit
Breaker
English