Filter
Top Products
DV300/DV301B 30" Multimedia Information Display
1. Safety and Installation
Safety precautions and maintenance
WARNING: Use of controls, adjustments or procedures other than those specified in this
documentation may result in exposure to shock, electrical hazards and/or mechanical
hazards.
Read and follow these instructions when connecting and using your monitor:
• Unplug the monitor if you are not going to use it for an extensive period of time.
• Unplug the monitor if you need to clean it with a slightly damp cloth. The screen many be wiped with a dry
cloth when the power is off. However, never use alcohol, solvents or ammonia-based liquids.
• Consult a service technician if the monitor does not operate normally when you have followed the
instructions in this manual.
• Only qualified service personnel should open the casing cover.
• Keep the monitor out of direct sunlight and away from stoves or any other heat source.
• Remove any object that could fall into the vents or prevent proper cooling of the monitor’s electronics.
• Do not block the ventilation holes on the cabinet.
• Keep the monitor dry. To avoid electric shock, do not expose it to rain or excessive moisture.
• If turning off the monitor by detaching power cable or DC power cord, wait for 6 seconds before re-
attaching the power cable or DC power cord for normal operation.
• To avoid the risk of shock or permanent damage to the monitor do not expose the monitor to rain or
excessive moisture.
• When positioning the monitor, make sure the power plug and outlet are easily accessible.
• IMPORTANT: Always have a screen saver program installed on your computer. If a still image in high
contrast remains on the screen for an extended period of time, it may leave an ‘after-image’ or ‘ghost
image’ on the front of the screen. This is a well-known phenomenon that is caused by the shortcomings
inherent in the LCD technology. In most cases the after-image will disappear gradually over a period of time
after the power has been switched off. Be aware that the after-image symptom cannot be repaired and is
not covered under warranty.
Consult a service technician if the monitor does not operate normally when the operating instructions given in
this manual have been followed.
Installation Locations
• Avoid exposure to heat and extreme cold
• Do not store or use the product in locations exposed to heat, direct sunlight or extreme cold.
• Avoid moving the product between locations with large temperature differences. Choose a site that falls
within the following temperature and humidity ranges.
• Temperature: 0-35°C 32-95°F
• Humidity: 20-80% RH
• Do not subject the product to severe vibration or high impact conditions. Do not place the product inside
a car boot.
• Take care not to mishandle this product by either knocking or dropping during operation or transportation.
• Do not store or use the product in locations where there is a high level of humidity or in dusty environments.
Do not allow water or other liquids to spill on or into the product.
4
Disclaimer
Mitsubishi Electric Australia Pty. Ltd. makes no representations or warranties, either expressed or implied, with
respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any
particular purpose. Further, Mitsubishi Electric Australia reserves the right to revise this publication and to
make changes from time to time in the contents hereof without obligation to notify any person of such revision
or changes.
Diamond Digital is a registered trademark of Mitsubishi Electric Australia Pty. Ltd.Microsoft and Windows are registered
trademarks of Microsoft Corporation. All other trademarks remain the property of their respective owners.
Reference Information
For future reference, write the following information about your monitor in the space below. The serial number
is found on the back of the product.
Monitor Information
Product Name: Diamond Digital DV300/DV301B
Serial Number:
Date of Purchase:
Dealer Information
Dealer:
Telephone Number:
Address:
3