Filter
Top Products
EN-16
Viewing video images (continued)
To stop projecting:
8. Press the POWER button on the projector or the OFF ( ) button on the remote control.
• A confi rmation message is displayed.
• To cancel the procedure, leave the projector for a while or press the MENU button.
9. Press the POWER button on the projector or the OFF ( ) button on the remote control again.
• The lamp goes out and the projector goes into a standby mode. In this standby mode, the POWER indicator
blinks red.
10. Wait about one minute for the POWER indicator to be lit in red steadily.
• During this period of one minute in the standby mode, the intake fan and exhaust fan rotate to cool the lamp.
• Do not unplug the power cord while the POWER indicator is blinking. Unplugging the power cord immediately
after use may cause a breakdown.
• Though the fan makes loud sounds during cooling, such symptom is not a malfunction.
11. Unplug the power cord from the outlet.
• Cover the lens with the lens cap to protect it from dust.
When projected images are distorted to a trapezoid:
With the control area of the projector:
1. Press the KEYSTONE button on the control area of the projector.
2. Equalize the widths at the top and bottom of the screen by pressing the
or
button, viewing the screen.
With the INSTALLATION menu:
(See Page 21 for menu setting.)
1. Display the INSTALLATION menu.
2. Select KEYSTONE by pressing the
or
button.
3. Equalize the widths at the top and bottom of the screen by pressing the
or
button, viewing the screen.
To cancel the menu:
4. Press the MENU button several times.
IRIS button
The iris function adjusts the contrast optically by opening and closing the lens aperture. The iris can be switched
between two modes, OPEN and CLOSE. When OPEN is selected, the image becomes brighter. When CLOSE is
selected, black levels of the image are reproduced with more clarity though the brightness is lowered.
When you press the IRIS button, the current setting appears. When pressing it again while the setting is being
displayed, the setting can be changed. It takes about 6 seconds for the iris to shift between OPEN state and CLOSE
state.
POWER STATUS
OFF ( ) button
KEYSTONE
INSTALLATION
SVGA60
0
opt.
AV MEMORY 1
POWER button