Filter
Top Products
EN-21
ENGLISH
Password function
This projector is equipped with the password function that is
designed for prevention of wrong operation by children and restriction
on operation by other than specified users.
MENU ACCESS ............All the buttons except for the POWER button
on the projector are disabled. (The buttons on the remote con-
trol are enabled.) You can use this mode as a measure of pre-
vention of wrong operation by children and restriction on
operation by other than specified users.
To enable the password function:
1. Display the FEATURE menu.
2. Press the S or T button to select PASSWORD FUNCTION.
3. Press the ENTER button.
• The screen for setting the password function will appear.
• When the password has already been set, the mode won’t
be changed. In such cases, press the ENTER button to can-
cel the password function and try again.
4. Press the ENTER button.
• The screen for entering a password will appear.
5. Press the W or X button to select a number from 0 to 9.
6. Press the ENTER button.
• You can set the next digit.
7. Repeat steps 5 and 6 to set a four-digit password.
8. Enter the password again for confirmation using the same
steps.
9. When the last digit has been entered, the password set up is
complete and the password menu will be off.
• If the entered passwords don't match, it will jump to the
INPUT PASSWORD field to start over again.
• To cancel the procedure, select Exit and press the ENTER
button.
• You can cancel the procedure by pressing the MENU button
alternatively.
To cancel the password function:
1. Display the FEATURE menu.
2. Press the S or T button to select PASSWORD FUNCTION.
3. Press the ENTER button.
• The screen for canceling the password function will appear.
4. Press the ENTER button.
• The screen for entering the password will appear.
5. Press the W or X button to select a number from 0. to 9.
6. Press the ENTER button.
• You can set the next digit.
7. Repeat steps 5 and 6 to enter the four-digit password.
8. When the last digit has been entered, the password set up is
complete and the password menu will be off.
• If the entered passwords don't match, it will jump to the
INPUT PASSWORD field to start over again.
• To cancel the procedure, select Exit and press the ENTER
button.
• You can cancel the procedure by pressing the MENU button
alternatively.
Important:
• If you forget your password, keep pressing the MENU and
ENTER buttons on the control panel at the some time about three
seconds to cancel the password function.
FEATURE
SVGA60
opt.
LOCK
OK
FEATURE
SVGA60
opt.
UNLOCK
OK