Mitsubishi Electronics WD385U-EST Projector User Manual


 
EN-14
Projector + Computer
For computer with Mini D-SUB
COMPUTER IN
MONITOR OUT
Audio cable (option)
PC audio cable (option)
To PC audio output
To monitor port
AUDIO IN-1
or IN-2
AUDIO
OUT
Necessary when outputting to both
a PC monitor and the projector.
Computer cable
Computer cable (option)
Computer
For analog connection:
1. Connect one end of the supplied computer cable to the COMPUTER IN terminal (1, 2) of the projector.
2. Connect the other end of the computer cable to the monitor port of the computer.
For monitor connection:
Connect the computer cable from the monitor to the MONITOR OUT terminal of the projector.
• Imagesmaynotbedisplayedcorrectlydependingonthetypeoftheinputsignal.Seetheinstructionmanualof
the monitor.
• SignalsarecomingfromtheCOMPUTERIN1terminaloftheprojector.
• WhentheStandbyModeintheInstallationmenuissettoMonitorOut,theMONITOROUTterminaloutputs
signals during standby mode.
Important:
• Whenyouusealongercomputercableinsteadoftheprovidedcable,theimagemaynotbeprojectedcorrectly.
• SomecomputersrequireadditionalconnectorsoranalogRGBoutputadapterstobeconnectedwiththis
projector. Contact your dealer for further information.
• Thisprojectorusesstereominijackforitsaudioinput.Checkthetypeoftheaudiooutputterminalofthe
connected computer and prepare a proper cable for connection. Some computers don’t have the audio output
terminal.
• Speakeroutputismono.
• WhentheaudiocableisconnectedtotheAUDIOOUTterminal,thespeakeroutputismuted.
For Macintosh
• IfyourMacintoshhasnovideoport,amonitoroutputadapterisrequired.Contactyourdealerforfurther
information.
• SomeMacintoshesrequireaMACadapterforthecomputercableforconnectionwiththisprojector.Contactyour
dealer for further information.
About DDC
The COMPUTER/COMPONENT VIDEO IN-1 terminal of this projector complies with the DDC 1/2B standard. When a
computer supporting this standard is connected to this terminal, the computer will automatically load the information
from this projector and prepare for output of appropriate images.
• Afterconnectingacomputersupportingthisstandardtothisterminal,plugthepowercordoftheprojectorinthe
wall outlet first, and then boot up the computer.
Basic connections (continued)