Mitsubishi Electronics XD3200U Projector User Manual


  Open as PDF
of 53
 
EN-9
Using the remote control
30°30°
30°30°
20°
10°
20°
10°
20°
20°
Operational range of the remote control
• Keeptheremotecontrolphoto-sensoroutofdirect
sunlight or fluorescent lamp light.
• Keeptheremotecontrolphoto-sensoratleast2m
(6 feet) away from fluorescent lamps. Otherwise, the
remote control may malfunction.
• Ifthereisaninverter-operateduorescentlampnear
the remote control, the remote control operation may
become unstable.
• Whenyouusetheremotecontroltooclosetothe
remote control sensor, the remote control may not work
correctly.
Reception angle
Vertical directions
Vertical directions (ceiling mount)
Front of projector
Rear of projector
Operate the remote
control within a distance
of 10 m (30 feet) from the
projector, pointing the
light beam at the remote
control photo-sensor (front
or rear) of the projector.
When operating the remote control, keep the
distance from the remote control to the projector
via the screen within about 5 m (15 feet). The
operable range of the remote control, however,
depends on the characteristics of the screen.
Using the wired remote control
Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired
remote control is useful for operating in a distance or outside of the operating area.
• Forconnection,usethepin-pincableofø3.5stereo
type, which is commercially available. However,
some cable may not work correctly.
• WhenREMOTEOUTterminalonthisprojectoris
connected to the REMOTE IN terminal on the other
projector, the two projectors can be controlled
together by using the remote control.
• Whentheremotecontrolisconnectedwithremote
control cable, it does not work as a wireless remote
control.
• Whenusingthewiredremotecontrol,thelaser
beam may be darker. It is normal.
REMOTE IN
REMOTE OUT
REMOTE IN
 previous next