Filter
Top Products
EN-32
Description of each menu
FUNCTION
(default setting/value)
DESCRIPTION (default setting/value)
Wall Color
(Off)
Corrects the projected picture’s color when the projection surface is not
white. See "Using Wall Color" on page 26 for details.
Aspect Ratio
(Auto)
There are four options to set the image's aspect ratio depending on your
input signal source. See "Selecting the aspect ratio" on page 23 for
details.
Keystone
(0)
Corrects any keystoning of the image. See "Correcting keystone" on page
22 for details.
Position
(0)
Displays the position adjustment page. To move the projected image, use
the directional arrow keys. The values shown on the lower position of the
page change with every key press you made until they reach their
maximum or minimum.
Phase
(depends on the selected input signal)
Adjusts the clock phase to reduce image distortion.
H. Size
(0)
Adjusts the horizontal width of the image.
Magnify
(1.0X)
Magnifies or reduces the projected image. See "Magnifying and
searching for details" on page 22 for details.
Setting
(PC Source: Photo;
Video source: Standard)
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting a picture
mode" on page 24 for details.
Color Mode
(Photo)
Selects a picture mode that most suits your need for the image quality and
further fine-tune the image based on the selections listed on the same
page below. See "Setting the User 1/User 2 mode" on page 24 for details.
Brightness
(50)
Adjusts the brightness of the image. See "Adjusting Brightness" on page
25 for details.
Contrast
(0)
Adjusts the degree of difference between dark and light in the image. See
"Adjusting Contrast" on page 25 for details.
Color
(0)
Adjusts the color saturation level -- the amount of each color in a video
image. See "Adjusting Color" on page 25 for details.
Tint
(0)
Adjusts the red and green color tones of the image. See "Adjusting Tint"
on page 25 for details.
The function is only available when Video or S-Video with NTSC
system is selected.
Sharpness
(15)
Adjusts the image to make it look sharper or softer. See "Adjusting
Sharpness" on page 25 for details.
BrilliantColor™
(On)
Adjusts white peaking while maintaining correct color presentation. See
"Adjusting BrilliantColor™" on page 25 for details.
Color Temperature
(T1)
See "Selecting a Color Temperature" on page 25 for details.
3D Color Management
See "3D Color Management" on page 26 for details.
Save Settings
Saves the settings made for User 1 or User 2 mode.
1. DISPLAY menu
2. PICTURE menu