Filter
Top Products
EN-10
Remote control effective range
Infra-Red (IR) remote control sensor is located on the front of the projector. The
remote control must be held at an angle within 30 degrees perpendicular to the
projector's IR remote control sensor to function correctly. The distance between
the remote control and the sensor should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR
sensor on the projector that might obstruct the infra-red beam.
Replacing the remote control battery
1. Pull out the battery holder.
Please follow the illustrated instructions. Push and hold the locking arm while pulling out
the battery holder.
2. Insert the new battery in the holder. Note the positive polarity should face
outward.
3. Push the holder into the remote control.
• Use of a battery of wrong type may cause explosion. Use Sony battery, type CR2025
only.
• Dispose of used batteries according to your local regulations. Discard used battery
promptly. Batteries may explode if mistreated. Do not recharge, disassemble, or dispose of in fire.
• Be careful in handling the battery according to the instructions.
• Load the battery with its positive (+) and negative (-) sides correctly oriented as indicated on the remote control.
• Keep batteries out of reach of children and pets.
• Remove the battery if the remote control is not used for a long time.
• Keep battery in original package until ready to use. Keep out reach of children.
• Never put battery in mouth for any reason as it can easily be accidentally swallowed. If battery is accidentally swallowed,
contact your physician or your poison control center.
A
p
p
r
o
x
.
1
5
°