Filter
Top Products
Command Parameter
^RB
Repeats the last printed batch, printing the same number of labels as
specified in the original batch. This command does not work if using batch
separators.
NOTE: Printer ignores this command if printing.
^RS
Resynchronizes supply when supply roll is changed.
NOTE: Printer ignores this command if printing.
^SD or
^SCd
Disables the status polling feature by turning off the status polling control
character. Sets the status polling control character to the ASCII value
given by the d parameter. The value of d can be any ASCII character.
^TP
Prints a test label set. NOTE: Printer ignores this command if printing.
The table represents the defined immediate command control
character as ^ and the defined status polling control character as
d. You may define these characters to suit your needs.
To use the immediate command control
character or the status polling character
within your data, use the tilde sequence.
Clearing Packets from Memory
You may want to remove packets from the printer to increase
memory storage capacity or if the formats/fonts are no longer
needed. In some cases, turning the printer off may clear the
packets from memory. If not, send a format clear packet.
Syntax
{header,packet#,action,device p }
1. header Identifies the packet. Options:
A Check Digit Scheme
F Format
G Graphic
W Font
2. packet# Identification number of the packet to clear (1-999) or font
number (0-9999). 0 is for all fonts.
3. action Enter C to clear the packet.
2-32
Configuring the Printer