Filter
Top Products
Intellio C218Turbo /PCI User's Manual 2-1
2
2
2 Hardware Installation
The installation of Intellio C218Turbo/PCI consists of hardware installation and
software installation. For software installation, please refer to the respective section
of operating systems in the next chapter. Hardware installation is stated in this
chapter. The no-switch-no-jumper
Intellio C218Turbo/PCI board’s hardware
configuration for IRQ and memory addresses is automatically assigned by
PCI
BIOS
. Hence, it is a must to have the board plugged first before installing
software driver
. After this, simply install the control board into the PC and then
connect one of the connection cable or box, Opt8A/B/C/D/S/J/F/Z. At the end of this
Chapter, RS-422/RS-485 operation of Opt8J is described.
Installing the Intellio C218Turbo/PCI Control Board
Step 1: Power off the PC.
Warning ! Make sure your system is switched off before you start installing any
board. If you don't, you may risk damaging your system and the
board.
Step 2: Remove the PC's cover.
Step 3: Remove the slot cover bracket if present.
Step 4: Plug the Intellio C218Turbo/PCI firmly into any free 32-bit PCI slot.
Step 5: Fasten the holding screw to make the Control Board fixed.
Step 6: Replace the system cover.