Filter
Top Products
2
22
2
2
Hardware Installation
The installation of the Smartio CP-104UL board involves both hardware and software.
Software installation is discussed in the next chapter. In this chapter, we discuss hardware
installation.
The no-switch-no-jumper
Smartio CP-104UL board’s IRQ number and I/O addresses are
assigned automatically by the PCI BIOS. For this reason, the board MUST be plugged in
before installing the driver software.
Installing the Smartio CP-104UL board
Step 1: Power off the PC.
Warning! To avoid damaging your system and board, make sure your PC’s
power is switched off before inserting this or any other board into
an empy PCI slot.
Step 2: Remove the PC’s cover.
Step 3: Remove the slot cover bracket if one is in place.
Step 4: Insert the
Smartio CP-104UL control board firmly into a free 32-bit PCI slot.
Step 5: Fasten the holding screw to fix the control board in place.
Step 6: Replace the PC’s cover.
Step 7: Power on the PC; the BIOS will automatically set the IRQ and I/O address.