Filter
Top Products
Software Installation
Smartio CP-104UL User’s Manual 3-31
13. Click [OK] in the Port X dialog box to confirm the port settings, and then click [OK] in the
Property dialog box to complete the port settings and return to the MOXA Smartio/Industio
Configuration Panel dialog box. The configured CP-168U board will now appear in the
MOXA Smartio/Industio Configuration Panel dialog box, as shown below.
14. Click [OK] in the MOXA Smartio/Industio Configuration Panel to return to the Network
dialog box, and then click [OK] to exit the Network dialog box.
15. Restart the PC.
NOTE
The driver configuration will NOT take effect until you restart the PC.
NOTE
Double check that all Smartio CP-168U board components—the control board—are connected and
fastened tightly to make sure that the system and the driver can start up successfully.
Once the system restarts, you may check the event log issued by the MOXA driver to see if the
board’s ports have been initialized successfully.
Enter the [Administrative] group, click the [Event Viewer] icon, and then select [Log] and
[System] to check a message similar to “MOXA CP-168U board, with first serial port COM3,
has been enabled” for each newly configured board.
NOTE
If an error message similar to “Cannot find any configured MOXA Smartio/Industio series board!”
pops up, refer to the Troubleshooting chapter for possible solutions.
Once the board and the driver are installed and the driver restarts successfully, you can start to
develop applications with the PComm library (see “Serial Programming Tools”) or the Microsoft
Win32 API. You can also use applications such as Terminal Emulator (see “Serial Programming
Tools”), a PComm utility, or HyperTerminal, to transmit/receive data, as well as Remote Access
Service to provide dial-up networking capabilities.
Configuring the Board and Ports
Re-Configuring Port Settings
If the driver is already installed, and you only wish to re-configure the ports, refer to the following
procedures. In addition to the procedures listed below, you may also click on [Start] " [Programs]