Filter
Top Products
Installing MOXA EtherDevice Switch
MOXA EtherDevice Switch Hardware Installation Guide
2
-
5
STEP 2:
Mounting MOXA EDS-508 on the wall requires 4 screws.
Use the EDS-508, with wall mount
plates attached, as a guide to mark the
correct locations of the 4 screws. The
heads of the screws should be less than
6.0 mm in diameter, and the shafts
should be less than 3.5 mm in diameter, as shown in the
figure at the right.
NOTE
Before tightening screws into the wall, make sure the
screw head and shank size are suitable by inserting
the screw into one of the keyhole-
shaped apertures of
the Wall Mounting Plates.
Do not screw the screws in all the way— leave about 2 mm to
allow room for sliding the wall mount panel between the wall
and the screws.
STEP 3: Once the screws are fixed in the wall, insert the four
screw heads through the large parts of the
keyhole-shaped apertures, and then slide EDS-508
downwards, as indicated below. Tighten the four
screws for more stability.