Filter
Top Products
Installing MOXA EtherDevice Switch
MOXA EtherDevice Switch Hardware Installation Guide
3
-
5
Wiring the Redundant Power Inputs
EDS-508 has two sets of power input— power input 1 and power input 2.The top
two contacts and the bottom two contacts of the 6-pin terminal block connector
on EDS’s top panel are used for dual DC power input. Top and front views of
terminal block connectors are shown here.
STEP 1: Insert the negative/positive DC
wires into the V-/V+ terminals.
STEP 2: To keep the DC wires from
pulling loose, use a small flat-blade
screwdriver to tighten the wire-clamp
screws on the front of the terminal block
connector.
STEP 3: Insert the plastic terminal block
connector prongs into the terminal block
receptor, which is located on EDS-508’s
top panel.