Filter
Top Products
3130
Troubleshooting
3130 3130
WAN Link LED is OFF; Cannot connect to a wireless network or
the Internet
If your Adapter appears to be functioning properly, but you cannot
connect to a network and the WAN link LED is OFF, the problem may
be that there is a mismatch between the network name (SSID) in your
wireless settings.
Check the SSID settings to see if they match. The SSID is case-
sensitive and the spelling on each computer must be exactly the same
in order for the adapter to connect to the Wireless Router or Access
Point. If the network has security (encryption) enabled, you will need to
enter the network key.
Note: To check the SSID settings, open an Internet browser and type
192.168.2.225 in the address bar to bring up the Adapter’s setup home
page. Click on Bridge Settings under the Settings menu to the left of
the window. The SSID setting is located under the Wireless Settings
status information.
WAN Link LED is solid but cannot connect to the Internet
If you have a signal but can’t get online or obtain an IP address, the
problem may be that there is a mismatch between the Encryption key
settings in your computer and Wireless Router or Access Point.
Check the WEP key settings to see if they match. The key is case-
sensitive and the spelling on each computer and Wireless Router or
Access Point must be exactly the same in order for the Adapter to
connect to the router. For more information about encryption please
go to page 21 of this manual.
If issues persist even at close range, please contact please contact
Belkin Technical Support.