Filter
Top Products
61
User Guide
-10 dBm is the transmit level
default.
S92 dBm 0 to -15 dB 10 Sets the transmit attenua-
tion level from 0 to 15 dBm for
the FAX mode, resulting in a
transmit level from 0 to -15 dBm.
In some countries, the transmit
level may not be changed and
there are checks to prevent
transmit attenuation level
change. -10 dBm is the trans-
mit level default.
S95 - Extended Result Codes
The bits in this register can be set to override some of the Wn command options.
A bit set to a 1 in this register will enable the corresponding result code regardless
of the Wn setting. Also, refer to Table 3-4.
Default: 0
Bit 0 CONNECT result code indicates DCE speed instead of DTE
speed.
Bit 1 Append/ARQ to CONNECT XXXX result code in error-correction
mode (XXXX = rate; see Table 3-4).
Bit 2 Enable CARRIER XXXX result code (XXXX = rate; see
Table 3-4.
Bit 3 Enable PROTOCOL XXXX result code (XXXX = protocol
identifier; see Table 3-4).
Bit 4 Reserved.
Bit 5 Enable COMPRESSION result code (XXXX = compression
type; see Table 3-4).
Bit 6 Reserved.
Bit 7 Reserved.