Filter
Top Products
MT5634ZPW-PCI
45
3 AT Commands, S-Registers and Result Codes
Command: &W
n
Store Current Configuration
Values:
n
= 0
Default: None
Description: &W0 Store active modem settings in NVRAM; load them at
power-on or following the ATZ command instead of
loading the factory defaults from ROM.
Command: &Y
n
Select Stored Configuration for Hard Reset
Values:
n
= 0
Default: 0
Description: &Y0 Select stored configuration 0 on power-up. (For
backward compatibility with some software.)
&Y1 Not supported—responds ERROR.
Command: &Z
n
=
x
Store Telephone Number
Values:
n
= 0, 1, 2, or 3
x = Dialing string
Default: None
Description: Stores telephone dial string
x
in memory location
n
.
Dial the stored number using the command
ATDS=n
.
Command: \G
n
Modem Port Flow Control
Values:
n
= 0
Default: 0
Description: \G0 Returns an
OK
for backward compatibility with some
software.
\G1 Not supported—responds ERROR.
Command: \J
n
Data Buffer Control
Values:
n
= 0
Default: 0
Description: \J0 Enable data buffer—serial port speed is independent
of connect speed.
\J1 Not supported—responds ERROR.
Command: \K
n
Set Break Control
Values:
n
= 5
Default: 5
Description: \K5 Modem sends break signal received from the DTE to
the remote modem.