Filter
Top Products
MT5634ZPW-PCI
76
Owner’s Manual
Appendix A: Regulatory Compliance
FCC Regulations for Telephone Line
Interconnection
1. This equipment complies with Part 68 of the Federal
Communications Commission (FCC) rules. On the outside
surface of this equipment is a label that contains, among
other information, the FCC registration number and ringer
equivalence number (REN). If requested, this information
must be provided to the telephone company.
2. As indicated below, the suitable jack (Universal Service
Order Code connecting arrangement) for this equipment is
shown. If applicable, the facility interface codes (FIC) and
service order codes (SOC) are shown.
An FCC-compliant telephone cord and modular plug is
provided with this equipment. This equipment is designed to
be connected to the telephone network or premises wiring
using a compatible modular jack which is Part 68 compliant.
See installation instructions for details.
3. The ringer equivalence number (REN) is used to determine
the quantity of devices which may be connected to the
telephone line. Excessive REN’s on the telephone line may
result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of the REN’s should
not exceed five (5.0). To be certain of the number of devices
that may be connected to the line, as determined by the total
REN’s, contact the telephone company to determine the
maximum REN for the calling area.
4. If this equipment causes harm to the telephone network, the
telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance
notice isn’t practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of
your right to file a complaint with the FCC if you believe it is
necessary.