Eizo F730 Computer Monitor User Manual


 
20
3 TROUBLESHOOTING
Problems
9) The entire screen appears too
dark or bright.
10) The screen is tilted/
distorted.
11) The image vibrates on the
screen.
Points to check with possible solutions
Adjust the contrast and brightness using the
ScreenManager. See page 11.
Output level from the computer may not conform the
monitor. Please set the video level using the
ScreenManager. See page 17.
Some signal timing can be the cause of this problem. To
correct this, turn off the monitor, then hold down the
AUTO-SIZING button and down arrow key while
turning on the monitor again. This will change the
signal timing and brighten the screen. If the above
operation si repeated the screen becomes dark again.
Adjust with the ScreenManager's tilt and distortion
correcting function until tilt/distorting seems
unnoticeable. See page 11.
Check to see if there are any nearby interfering
electronic devices such as another monitor, an electric
motor, or a speaker (other than an optional EIZO
i·Sound speaker unit.) If so, move the device or move
the monitor.
It is sometimes possible to correct distortion and tilting
by reorienting the monitor.
Use of the Moiré” adjustment may cause a slight.
vibration. To eliminate the vibration, set the adjustment
level to lower percentage or 0%. See page 12.
Check that the signal cable is properly connected to the
graphics board or PC.
Check that the graphics board is correctly mounted in
the PC.
The monitor may be located close to a device that is
generating a magnetic field. Such devices include
speakers (other than the EIZO optional i·Sound
speaker), electric motors, high-voltage cables, and other
monitors. It may be solved by switching off or moving
the interfering device, or by relocating the monitor.
If the volume level of the EIZO optional i·Sound speaker
is too high, it may, in some cases, cause a slight vibra-
tion. To eliminate, turn down the volume of the speaker.
· An unstable signal from the graphics board may be the cause of the above problem when
using the monitor with a high resolution or in a high refresh mode. (The video signal from
the graphics board might be made irregular due to the use of a high speed dot clock.)
Change the resolution or the refresh rate to another setting.