Filter
Top Products
E
13
1 INSTALLATION
Attaching an Arm Stand to the Monitor
WARNING
• When attaching the monitor to the mount, use the enclosed screws
and tighten them securely. When reattaching the monitor to the tilt
stand, use the screws that was attached to the monitor originally.
By not doing so may result in injury or failure of the monitor. To attach the
mount to the monitor, please read the instruction manual of the mount.
• Use a VESA approved arm-stand. The LCD
panel requires 75 mm x 75 mm hole spacing on
the arm mounting pad. The arm-stand should
be able to support an object weighing 8.0 kg.
• In case of using this LCD monitor with an
arm-stand in an office workspace, the arm-
stand shall be chosen and used carefully:
- Use only an approved arm-stand (e.g. GS).
- The arm-stand shall have sufficient stability
(mechanical firmness) to support the weight
of the monitor.
- The arm-stand shall remain in that position
where it is manually moved.
- The arm-stand shall have the ability to tilt
the monitor forward and backward.
- The height of the upper row shall be less
than or equal to 500 mm in relation to the
desk surface when the arm-stnad is in its
lowest osition.
(1)Lay the LCD monitor down as shown below, not scratching the panel.
Remove the tilt loosening the screws. When re-attaching the tilt, use
the enclosed screws and fix the tilt to the monitor securely.
(2)Place and fix a mount or an arm-stand to the monitor securely.
Soft Cloth or
Cushion
500 mm
75 mm
x
75 mm
(Example)
4 Mounting
Screws
(enclosed):
4x16 (mm)