Filter
Top Products
● When using FD-C16, plug the D-Sub mini 15 pin connector to the computer and DVI-I connector to
the monitor. Wrong connection causes no picture problem.
Selecting the Active Input
The Input Signal Selection switch on the control panel can be used to select either SIGNAL 1 or SIGNAL
2 as the active input at any time. Every time the switch is touched, the input changes. When switching the
signal, the kind of the input signal (Signal 1 or 2/ Analog or Digital) is displayed for a few seconds on the
right top corner of the screen.
The Priority Input Signal
This function is used to select which PC will have priority to control the monitor when utilizing two PCs.
The monitor constantly checks the input signals and switches automatically in accordance with the "Input
Priority" setting (see table below). Once a priority is set, whenever a change of signal is detected at the
selected input, the monitor will switch the input to that signal.
In the case of only one signal being present at either input, the monitor automatically detects and displays
that signal.
Priority setting
Performance
1
(SIGNAL 1 - DVI-I Input Connector)
If signals from both inputs are present, the monitor gives preference to
Signal 1 in the following cases.
● When the power of the monitor is turned ON.
● When the signal input to Signal 1 is changed even if active input was
Signal 2.
2
(SIGNAL 2 - DVI-I Input Connector)
If signals from both inputs are present, the monitor gives preference to
Signal 2 in the following cases.
● When the power of the monitor is turned ON.
● When the signal input to Signal 2 is changed even if active input was
Signal 1.
Manual
The monitor will not detect signals automatically in this mode. Select the
active input by pressing the Input Signal Selection Button on the monitor's
control panel.
● When the "1" or "2" is selected, the power saving mode of the monitor activates only if both PCs are in
power saving mode.