Filter
Top Products
7. TROUBLESHOOTING
If a problem persists even after applying the suggested remedies, contact an EIZO dealer.
● No picture problems → See No.1 ~ No.2
● Imaging problems → See No.3 ~ No.14
● Other problems → See No.15 ~ No.19
● USB problems → See No.20 ~ No.21
Problems
Points to check with Possible
Solutions
1. No picture
● Indicator status: Off
● Check that the power cord is
correctly connected. If the
problem persists, turn off the
monitor power for a few
minutes, then turn it back on
and try again.
● Try touching the Power switch.
● Indicator status: Blue ● Check the "Brightness" setting.
● Indicator status: Yellow
● Switch the signal input by
pressing the Input Signal
Selection switch on the front
control panel.
● Try touching a key on the
keyboard, or clicking the
mouse .
2. Error messages shown below will remain on the screen for
40 seconds.
These messages appear when the
signal is not inputted correctly,
even if the monitor functions
properly.
● When the image is displayed
correctly after a short time,
there is no problem with the
monitor. (Some PCs do not
output the signal soon after
powering on.)
● Check that the PC is turned ON.
● Check that the signal cable is
properly connected to the PC or
graphics board.
● Switch the signal input by
touching the Input Signal
Selection switch on the control