Filter
Top Products
Chapter 1 Installing and Configuring the SCXI-119X
SCXI-1190/1191/1192 User Manual 1-6 ni.com
Note
When installing the SCXI-119X moduleinanSCXIchassis,fillslot1first,thenfill
slot 2 with the next SCXI-119X.
5. Insert any other SCXI modules into the remaining slots in the same
manner as described in step 4.
6. Secure all the SCXI-119X modules to the SCXI chassis by tightening
both module thumbscrews.
Connecting the SCXI-119X to a DAQ Device or Computer-Based
Instrument
You need the following items:
• SCXI chassis with the SCXI modules installed (Refer to the Installing
the SCXI-119X Module into an SCXI Chassis section for more
information.)
• SCXI cable assembly, which consists of a cable adapter and a cable
• An installed National Instruments DAQ device or computer-based
instrument, such as the NI 4060, that is able to control the SCXI
chassis
• 1/4 in. flathead screwdriver
Consult your SCXI chassis documentation, other SCXI module
documentation, and DAQ device or computer-based instrument
documentation for additional instructions and warnings. Your SCXI-119X
module and any other SCXI modules should already be installed in the
chassis according to their installation instructions.
You must select one of the modules in the chassis as the cabled
module—the module to which the SCXI cable assembly connects. If the
chassis contains at least one SCXI-1140 module, select an SCXI-1140 as
the cabled module; otherwise, select one of the remaining modules.
Note
The SCXI-119X modules operate only in multiplexed mode.