Filter
Top Products
Index
DAQArb 5411 User Manual I-4
©
National Instruments Corporation
mechanical specifications, A-6
memory, waveform. See waveform memory.
memory module, installing, 2-2
minimum buffer size and resolution, 4-5
N
National Instruments application software,
1-3 to 1-4
NI-DAQ driver software
installing latest version (note), 2-1
overview, 1-4
O
operational mode specifications, A-4
output. See analog output; SYNC output.
P
PA<0..15> signal (table), 3-6
PCLK signal (table), 3-6
phase-locked loops, 4-22 to 4-24
architecture (figure), 4-22
master/slave operation, 4-23 to 4-24
PLL Ref connector, 3-3 to 3-4
pin assignments
Dig Out connector (figure), 3-5
SHC50-68 50-pin cable connector
(figure), 3-7
PLL Ref connector, 3-3 to 3-4
Plug and Play capability, 1-1, 4-1
power-up and reset conditions, 3-8
pre-attenuation offset, 4-18, 4-21
R
reference clock, PLL Ref connector, 3-3
requirements for getting started, 1-2
reset conditions, 3-8
RFU signal (table), 3-6
RTSI trigger lines, 4-27 to 4-28
locking DAQArb 5411 to other National
Instrument cards (note), 3-3
purpose and use, 4-27 to 4-28
specifications, A-4
trigger lines and routing (figure), 4-27
S
sequence list, 4-5
SHC50-68 50-pin cable connector, 3-6 to 3-7
signal connections, 3-1 to 3-8
I/O connector, 3-1 to 3-6
ARB connector, 3-2
DAQArb 5411 connector
(figure), 3-1
Dig Out connector, 3-4 to 3-5
pin assignments (figure), 3-5
PLL Ref connector, 3-3 to 3-4
SYNC connector, 3-3
power-up and reset conditions, 3-8
SHC50-68 50-pin cable connector,
3-6 to 3-7
signal descriptions (table), 3-6
sine spectral purity specifications, A-2
single trigger mode
Arb mode, 4-12 to 4-13
DDS mode, 4-13
software programming choices, 1-3 to 1-4
National Instruments application
software, 1-3 to 1-4
NI-DAQ driver software, 1-4
specifications
analog output, A-1
bus interface, A-4
digital pattern output, A-5
external clock reference input, A-6
filter characteristics, A-2 to A-3
internal clock, A-6
marker output, A-5