Filter
Top Products
Chapter 1 Introduction
NI PCI-1410 User Manual 1-2 ni.com
Refer to Figure 1-1 for the location of the NI 1410 W1 jumper and the
connectors discussed in this manual.
Figure 1-1. NI PCI-1410 Parts Locator Diagram
Software Overview
Programming the NI 1410 requires the NI-IMAQ driver software for
controlling the hardware. National Instruments also offers the following
application software packages for analyzing and processing your acquired
images.
• Vision Builder for Automated Inspection (AI)—Allows you to
configure solutions to common inspection tasks.
• National Instruments Vision Development Module—Provides
customized control over hardware and algorithms.
The following sections provide an overview of the driver software and the
application software. For detailed information about individual software
packages, refer to the documentation specific to each package.
1 68-Pin VHDCI Connector
2 BNC Connector
3 W1 Jumper
4 RTSI Bus Connector
4
3
1
2
NI PCI-1410
COPYRIGHT 2004
NATIONAL INSTRUMENTS
©