Filter
Top Products
Appendix F Troubleshooting and Common Questions
PXI-846x and NI-CAN for Windows NT F-2 ni.com
NI-CAN Software Problem Encountered
This error occurs if the NI-CAN Diagnostic utility detects that it is unable
to communicate correctly with the hardware using the installed NI-CAN
software. If you get this error, shut down your computer, restart it, and run
the NI-CAN Diagnostic utility again. If the problem persists, try
reinstalling the NI-CAN software for Windows NT.
Missing Board in Diagnostic Utility
If your board is physically installed in your system, but is not listed in the
NI-CAN Diagnostic utility, check to see if the NI-CAN Configuration
utility has detected the board. For more information, refer to the Missing
Board in the NI-CAN Configuration Utility section earlier in this appendix.
Hardware Problem Encountered
This error occurs if the NI-CAN Diagnostic utility detects a defect in the
hardware. If you getthis error, writedown the numeric code shown with the
error and contact National Instruments. Depending on the cause of the
hardware failure, you may need to repair or replace your board.
Common Questions
How can I determine which type of CAN hardware I have installed?
Run the NI-CAN Configuration utility. To run the utility, select
Start»Settings»Control Panel»NI-CAN Configuration. If any hardware
is correctly installed, it is listed under National Instruments CAN
Interfaces.
How can I determine which version of the NI-CAN software I have
installed?
Run the NI-CAN Diagnostic utility. To run the utility, select the NI-CAN
Diagnostic item under Start»Programs»National Instruments CAN.
The NI-CAN Diagnostic utility displays information about the version of
the NI-CAN software currently installed.
How many PXI-8460, PXI-8461, and PXI-8462 boards can I configure
for use with my NI-CAN software?
The NI-CAN software for Windows NT can be configured to communicate
with up to 10 boards.