Filter
Top Products
8-32
Removing PCI Module
Follow the procedure below to remove the PCI module.
96. Stop the PCI module you want to remove.
To this end, use the ft server utility of the NEC ESMPRO Agent installed to your server or
the Data Viewer of the NEC ESMPRO Manager.
For more information, see "NEC ESMPRO Agent and Manager" - "Maintenance of NEC
Express5800/ft series" in Chapter 5.
NEC ESMPRO Manager
Select [FTServer] → [PCI Module] → [PCI Module
(to be removed)] → [Maintenance] → [Bring
Up/Bring Down] → [Bring Down].
ft server utility
Select [ft server] → [PCI Module] → [PCI Module
(to be removed)] → [PCI Module Start/Stop] →
[Stop].
After the CPU enters into off-line status, the status LEDs of the PCI board and PCI
module will change as follows.
PCI board slot status LEDs (all of them): Off
PCI module
Fail LED: Red
State LED: Off
97. <Tower model>
Unlock the front bezel with the security key and open it.
<Rack-mount model>
Unlock the front bezel with the security key and remove the upper and lower panels.
98. Disconnect the PCI module’s network cable and cables connected to the options.
99. Loosen the setscrew securing the PCI module’s release lever.