NEC L234GC Computer Monitor User Manual


 
8
Connecting to a Antenna / Cable
Make sure that the power switch of the LCD MONITOR is turned off and that the unit is disconnected from the AC power source.
Precautions when connecting the antenna
z
Use a coaxial cable which is free from interference. Avoid using a parallel flat wire as interference may occur, causing the reception to become unstable and
noise to appear on the screen.
z
Avoid using an indoor antenna as this may be affected by interference and poor reception.
z
Keep the power cord as far away from the antenna wire as possible.
z
Auto Tuning please refer to page 24
VHF(300-Ohm) antenna / UHF antenna
When using a 300-ohm twin lead from an outdoor antenna, connect the VHF or UHF antenna leads to the screws of the VHF or UHF adapter. Plug
the 300-ohm to 75-ohm adapter into the antenna on the LCD MONITOR.
When both VHF and UHF antennas are combined
Attach an optional antenna cable signal combiner to the LCD MONITOR antenna terminal, and connect the cables to the antenna mixer. Consult your
local electronics retailer about available signal combiners.
Reconnect the unit to the AX power source and turn on the power.
Using the Remote Control or User Controls, select the "CHANNEL SETTING MENU". Select the appropriate menu based upon which source (cable
or antenna) is being used.
Refer to pages 15 and 16 for further information on the "CHANNEL SETTING MENU" as well as for information on how to use the "AUTO
PROGRAM" function to program available channels.
Monitor rear panel
Antenna
InsIns
InsIns
Ins
tt
tt
t
aa
aa
a
llatllat
llatllat
llat
ion Insion Ins
ion Insion Ins
ion Ins
tructruc
tructruc
truc
tt
tt
t
ionsions
ionsions
ions continued