Filter
Top Products
8-26 Troubleshooting
Problems with Configuration Diskette Creator
The bit map of the Configuration Diskette Creator window is not displayed correctly
during setting of setup information. (When the Trekking command is used)
→ If the specified number of colors is fewer than 256 in the display setting, the bit map
is not displayed correctly, but the setup information can be displayed correctly.
The Point to Point tunneling protocol cannot be set.
→ The protocol is not supported at present. After installation, set the protocol through
Control Panel. In this case, rebooting is not necessary.
The details of a network adapter cannot be set.
→ Configuration Diskette Creator is unable to set the details of network adapters. Start
Windows 2000/Windows Server 2003, and set the details through Control Panel.
More than one network board is connected during setting of setup information, but
TCP/IP cannot be set for each network.
→ Perform the installation procedure during DHCP setting. To create a temporary IP
configuration, perform the installation procedure during DHCP setting, and then set
TCP/IP again through Control Panel.
Problems with Disk Array Configuration
Refer to the manual that comes with the disk array controller for any trouble occurred on disk array
in this system.