Filter
Top Products
1. What’s in the Box? and the Names of the Projector Parts
10
1-3-2. Rear of the projector
4
5
2
1
3
1. AC power cable
This is the cable that supplies AC power to the projector head. The AC power cable is not an accessory. Consult with your
dealer/distributor about the AC power cable.
2. Level adjusters (in four positions on bottom)
In the ordinary installation, you can adjust the projector inclination at 4 positions.
3. Air inlet
Air is taken in here to provide cooling of the projector. Do not cover the air inlet.
4. Lamp door
This opens to allow the lamp to be replaced. Please contact your dealer/distributor to install and to replace the lamp bulb
and lamp house.
5. Rear status indicator
These indicate the status of the projector. When the projector is operating normally, these light/blink in green or orange.
When an error occurs, they light/blink in red. When an error occurs, check the contents of the display on the LCD screen.
(See page 42)
NOTE
Do not cover the air inlet during operation. Inadequate air intake may lead to a rise in inside temperature, thus
causing a free or serious projector failure.
CAUTION:
Only service personnel should open the lamp door.