Filter
Top Products
English
English-5
Screw Holes
Clamper
Cord or Chain
Screw
To avoid falling down
Fasten the LCD monitor to a wall using a cord or chain which is
sufficient to support the weight of the LCD monitor (approx. 28kg).
Before moving the LCD monitor, the cord or chain should be re-
moved.
Table
Protective Shee
t
Tabletop Stand
You can attach mounting accessories to the LCD monitor in one of
the following two ways:
1. In the upright position
Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding
objects as shown in the diagram to the right.
Attaching LCD Options
2. Lay the screen face down
To avoid damaging the screen face, place the protective sheet on
the table to lay the LCD on. The protective sheet was wrapped
around the LCD in the original packaging.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. For proper installation it is strongly
recommended to use a trained, NEC authorized service person.
Failure to follow NEC standard mounting procedures could result in
damage to the equipment or injury to the user or installer. Product
warranty does not cover damage caused by improper installation.
Failure to follow these recommendations could result in voiding your
warranty.
When using mounting accessories, other than NEC compliant and
approved, they must be VESA
®
-compatible mounting method. NEC
strongly recommends using screws M6 size and 8mm in length. If
using screws longer than 8mm, check the depth of the hole.
(Recommended Fastern Force: 274 ~ 362N•cm)
NEC recommends using mounting interface that comply with UL1678
standard in North America.
*Ambient temperature should be less than 40 deg C
*