NEC PlasmaSync 3300 Computer Monitor User Manual


 
Position Controls
The Position controls allow you to adjust the position of the image.
38
37
Position Down/Up : moves the image vertically up or down.
Position Left/Right : moves the image horizontally left or right.
POSITION/CONTROL Up/Down : moves the arrow up or down to select one of
the choices.
POSITION/CONTROL +/- : moves the bar to increase or decrease the ad-
justment.
EXIT : exits to the main menu.
NORMAL (RASTER) : resets the current menu control to the factory
setting.
Auto Picture Control (Picture ADJ/Fine Picture)
The Auto picture control allows you to adjust the Picture Adjustment and Fine
Picture.
Position
Down/Up
Left/Right
Position
+
-
Position
Down/Up
Left/Right
Position
+
-
Auto Picture : Off
Picture ADJ
Fine Picture
Auto Picture
+
-
•The Picture Adjustment control allows you to fine tune the computer image
or to remove vertical banding that might appear. This function adjusts the
clock frequencies that eliminate banding in the image.
•The Fine Adjustment adjusts the clock phase or reduces video noise, dot
interference or cross talk. (This is evident when parts of the image appear to
be shimmering.)
NOTE:
•The Picture ADJ and Fine Picture features are available only when
the Auto Picture is off. The Picture ADJ and Fine Picture features are
not available for Video or S-Video source.
•When the Auto Picture is on, the Picture ADJ and Fine Picture
adjustments are made automatically.
POSITION/CONTROL Up/Down : moves the arrow up or down to select one of
the choices.
POSITION/CONTROL +/- : moves the bar to increase or decrease the ad-
justment.
EXIT : exits to the main menu.
NORMAL (RASTER) : resets the current menu control to the factory
setting.
Display Mode
Display Mode provides you information about the current resolution display
and technical data including the horizontal and vertical frequency.
Mode : indicates the resolution of the current input signal (dot x line).
H. Freq : indicates the horizontal frequency of the current input signal.
V. Freq : indicates the vertical frequency of the current input signal.
H. Pol:indicates the polarity of the horizontal sync. signal.
V. Pol : indicates the polarity of the vertical sync. signal.
Neg : indicates the polarity is negative.
Pos : indicates the polarity is positive.
Source : indicates the current input source.
Memory : indicates the memory area.
EXIT : exits to the main menu.
NOTE: Vertical frequencies identified by the OSM System's Display Mode
function may exhibit variances from the actual vertical frequency of the
connected input source. Vertical frequencies between 60-70 Hz may vary by
+/- 3 Hz; vertical frequencies from 70 Hz to 100 Hz may vary by +/-5 Hz. In
these situations, it is recommended that the vertical frequency identified by
the OSM System Display Mode function be regarded as an approximate
reference within tolerances stated above.
RGB
VIDEO
Display Mode
Mode : 640 x 480
H Freq. : 31.47 kHz
V Freq. : 60 Hz
H Pol. : Neg
V Pol. : Neg
Source : RGB 1
Memory : Factory
Display Mode
Mode :NTSC
Source : Video 1