Filter
Top Products
10 NEC PowerMate eco Getting Started Guide
5.
Install the memory module as follows.
Note
To remove an already installed memory module, see “Removing a Memory Module”
following this procedure.
Before handling any internal components, discharge static electricity
from yourself by touching a nearby unpainted metal surface.
Locate the alignment notch on the memory module (see the following figure).
Align the notch with the key in the slot connector.
Holding the memory module at a 45-degree angle, insert the module connector into the
socket. Firmly push the module into the socket.
Press down on the edge of the memory module until the locking tabs on the sides of the
socket snap into place, securing the module.
Installing the memory module
A
– Locking Tab
C
– Memory Module
B
– Module Alignment Notch