Filter
Top Products
Max 410/420/430 User’s Guide – Chapter 3
23
Entering an IP Address from a Telephone
Keypad (Max 420/430)
Ask your Network Administrator for the IP address that will
be assigned, the LAN’s netmask address, domain name,
and any other IP parameters that can be provided.
To enter an IP address:
1. Lift the telephone handset and dial ***2 (the IP
address parameter code).
The voice prompt responds, “Please enter your
IP address.”
2.
Dial the numbers for the IP address you wish to
enter on the telephone keypad. Use the star key
(*) to replace the periods in the address and end
with the pound key (#).
For example, if you want to enter the IP address
192.168.172.19, you would enter
192*168*172*19# from your telephone keypad.
The voice prompt responds, “Your IP address
is…” and repeats the address you entered.
3.
If the new address is correct, simply hang up the
telephone. If the new address is incorrect, hang
up the telephone and repeat from step 1, above.
4.
Reset the Max 420 to activate the changes. To
do this, power-off the unit, wait 10 seconds, and
turn it on again.
You are now ready to finish setting up the Max 420 using
the Max Web Manager. Proceed to Chapter 3, Logging
Into the Max Web Manager.
Entering a Netmask Address from a Telephone
Keypad (Max 420/430)
To enter a netmask address:
1. Lift the handset and dial
***3 (the netmask
parameter code).
The voice prompt responds, “Please enter your
netmask.”
2. Proceed as in step 2, above, entering the desired
netmask address from the telephone keypad.