Filter
Top Products
www.netcomm.com.au Rev. 1- YML674
Page 10 NB1300Plus4 ADSL Modem
Overview
8. Click the Configure My Router button and follow the on-screen prompts. The software will
ask you to ensure your router is powered on, click OK to continue.
9. When prompted you should power off your router and then power it back on again. You can
close Easy Config at this point by clicking the Exit button.
Note: It may also be beneficial to reboot your computer but this is usually not
required.
10. Once your NB1300Plus4 has booted (RDY light pulses) wait one minute and you should
now be able to connect to the Internet. You can run Easy Config again just to check your
connection status.