Filter
Top Products
www.netcomm.com.au Rev. 1- YML674
Page 24 NB1300Plus4 ADSL Modem
ADSL Gateway
Router - Ethernet
Step 1: Connecting your computer to the NB1300Plus4
Note: This unit should only be connected to the Telecommunications Network through a
line cord which meets the requirements of ACA TS008.
a. Connect your NB1300Plus4 to either a computer directly or a network hub or switch using
cat5 ethernet cables. You need to ensure you are using the correct type of ethernet cable - i.e.
straight through or crossover.
b. Connect one end of the ADSL phone line to the NB1300Plus4 ADSL Modem and the other
end to the wall socket.
c. Connect the power pack to the NB1300Plus4 ADSL Modem and switch on the power
switch.
d. Ensure that there is a LAN link light on the NB1300Plus4.
e. Ensure that the computer you intend to use has an IP address in the same subnet as the
NB1300Plus4 ADSL Modem. (e.g. the NB1300Plus4’s default IP is 192.168.1.1 - your
computer should be on 192.168.1.100 or similar.) If you have DHCP enabled on your
computer, the NB1300Plus4 will assign your computer a suitable IP address.
f. Ensure that your computer has a LAN link light.
Step 2: Configuring the NB1300Plus4
After connecting all the ADSL Router cables you can either configure your NB1300Plus4 using
the Easy Config software provided (Refer to page 9) or complete the following manual
configuration instructions:
a. After connecting all the ADSL Router cables, powering on the ADSL Router, and launching a
web browser, such as Internet Explorer or Netscape Navigator, browse to the address http://
192.168.1.1.