Filter
Top Products
YML854 Rev1 NB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4WnNB6, NB6W, NB6Plus4, NB6Plus4W, NB6Plus4Wn User Guide
www.netcomm.com.au 53
MTU: (refer to the WAN section)
The default MTU value for LAN side Settings is 1500. You may modify it if necessary.
DHCP Server On:
Check this item if DHCP service is needed on the LAN side. The router will assign IP address and
gateway address for each of your PCs.
Start IP Address & End IP Address:
Enter the information needed.
Lease Time:
Key in the duration for the time. The default is 1day.
DHCP Server Off:
Check this item if DHCP service is not needed on the LAN.
On this web page, the primary IP address and subnet mask will be shown. You can modify them if needed.
Key in all the necessary settings and click Next.
You can check the contents on the Summary page.
If you find anything incorrect, click Back to modify the settings.
If everything is OK, click Finish to accept these settings.
Now, the system will reboot to activate the new settings that you have set in this section.
Please wait for 2 minutes before restarting the router.