NETGEAR DGND3300-100NAS Network Router User Manual


 
Appendix C. NETGEAR VPN Configuration | 157
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
The LAN addresses used in this example are as follows:
a. For the connection name, enter toFVL328.
b. For the remote WAN's IP address, enter fvl328.dyndns.org.
c. Enter the following:
IP Address. 172.23.9.1
Subnet Mask. 255.255.255.0
5. Configure the FVL328 as in the gateway-to-gateway procedures for the VPN Wizard (see
Setting Up a Gateway-to-Gateway VPN Configuration on page 90), being certain to use
appropriate network addresses for the environment.
a. For the connection name, enter toDGND3300v2.
b. For the remote WAN's IP address, enter dgnd3300v2.dyndns.org.
c. Enter the following:
IP Address. 10.5.6.1
Subnet Mask. 255.255.255.0
6. Test the VPN tunnel by pinging the remote network from a PC attached to the N300
Wireless Dual Band ADSL2+ Modem Router DGND3300v2.
a. Open the command prompt (select Start > Run > cmd)
b. Type ping 172.23.9.1.
If the pings fail the first time, try the pings a second time.
Configuration Summary (Telecommuter Example)
The configuration in this section follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather the necessary information before you begin configuration.
Device LAN IP Address LAN Subnet Mask
DGND3300v2 10.5.6.1 255.255.255.0
FVL328 172.23.6.1 255.255.255.0