Filter
Top Products
6-4 Getting Started Guide
1. ADSL Line Configuration
1. Select Trellis Coding Enabled. Toggle it to On (the default) or Off. Unless otherwise specified by your
provider, you can accept this default.
2. Select Fast Retrain Enabled. Toggle it to On (the default) or Off. Unless otherwise specified by your
provider, you can accept this default.
3. The Wiring Type pop-up menu allows you to choose the type of copper pair wiring in use at your location.
The Router is preset to AutoSense, so that it will try both common types automatically, without any
adapters required. You can choose your own type, if you know it. Tip/Ring (Inner Pair) is the most common
type. If you know that you have the reversed inner/outer pair type of wiring, choose A/A1 (Outer Pair) from
the pop-up menu.
4. Select Data Link Encapsulation and from the pop-up menu choose either RFC1483 (the default) or PPP.
5. The next two fields, Data Circuit VPI and Data Circuit VCI are editable. Enter the Virtual Path Identifier and
Virtual Channel Identifier values that your provider specifies. VPI 8/VCI 35 are the most common. Your
provider must specify these values.
6. Press the Down arrow key until you reach NEXT SCREEN. Press Return to bring up the next screen.
ADSL Line Configuration
Trellis Coding Enabled: On
Fast Retrain Enabled: On
Wiring Type... AutoSense
Data Link Encapsulation... RFC1483
Data Circuit VPI (0-255): 8
Data Circuit VCI (32-65535): 35
PREVIOUS SCREEN NEXT SCREEN
Return/Enter brings you to next screen.