Filter
Top Products
10003137.00 Rev.1
4-4 Commands
Commands
This section describes the available commands. You should note that not all commands
are available in every analyser state. You can display a complete list of the commands
available in the current state using the MORE key.
Capt
Toggles capture to disk. If capture is OFF, you must supply a filename for the capture
file. This should be a legal DOS filename, for example, CAPTURED.OUT. All
transmitted and received messages are stored in this file. Files can be played back using
the Play command.
All messages that pass through the Filter (see Filt) are stored regardless of the settings
of L2, L3 and LONG, MEDium and SHORT. To end capture, either press Capt again or
press Stop. If the disk fills up capture terminates.
When capture is ON, CAPT is displayed in field 9.
Cause
Displays a list of causes and their values.
Cont
Continues display after the display has been paused to examine data. The display can
also be continued using the down arrow (
↓) or Page Down keys to move past the end of
the display.
Dial
Dials a remote number before monitoring starts. Requires an AT modem, or a QDLM or
ADLM.
Filt
Enables or disables a filter. If a filter is not enabled, you must supply the name of a filter
that you want to use to select messages for display. If a filter is enabled, it is removed
and all messages are displayed. The status line indicates FILT when filtering is enabled
in the Filter/Capture field. If both filtering and capturing are on, CA-FI is displayed.
You must define a filter before you can use the Filt command (see MakeF).
Hang
Disconnects a remote monitoring call.