Filter
Top Products
Tapping a WAN connection
Chapter 2 Installing Your GigaStor
43
rev. 1
Now that you have physically connected the cables for the GigaStor,
you must now configure its software. See “Setting the GigaStor’s IP
address” on page 19.
Figure 27 shows the GigaStor as it would be cabled to analyze T1/E1
link with a Channel Service Unit/Data Service Unit (CSU/DSU)
1
.
Figure 27 Digital T1/E1 Tap
1. The 4-Port version of this system has an additional PC interface card and an additional TAP and cable kit. Connect
the second TAP kit as shown in the diagram.
T1 Line (DCE)
Router or
CSU/DSU (DTE)
10/100/1000
NIC for TCP/IP
Gen2
GigaStor or
GigaStor Expandable
T1 TAP
Observer Console