Filter
Top Products
NTI RACKMUX Console Drawer with UNIMUX Switch
19
F3- Display Information
To display information about a selected port, pressing the <F3> key from within the Command Mode main menu will cause a
window to open. The window will show the name of the port and its position in the system structure, level by level. This is most
useful when cascading switches (for Cascading see page 20). An example of this structure might be
LEVEL 1 : PORT 5
LEVEL 2 : PORT 3
This means that the CPU connected through this port is actually connect through Port 5 of the master switch (Level 1), and
through port 3 of the slave connected to port 4 (Level 2). See Fig. 20 below.
Figure 20- Information provided by the F3 command
No Sun Sleep Mode
PLEASE NOTE: It is necessary to configure a Sun CPU (most versions) such that the Sleep Mode is not enabled. If the
Sun CPU goes into Sleep Mode either automatically or manually, the user must reboot the Sun CPU in order to resume
use of the Sun CPU.
To disable the Sleep Mode, perform the following steps:
1. Select "Power Manager"
2. Look for "Device Idle Time Before Power Saving Starts"
3. Select "Always ON"
4. Look for "Override Device Idle Time For:"
5. Make sure neither "Monitors " nor "Disks" are selected.
CPU
UNIMUX
SLAVE
CPU PORTS
USER PORTS
UNIMUX
MASTER
CPU PORT5
USER PORTS
CPU PORT3
USER 1
LEVEL 1
LEVEL 2