Filter
Top Products
Remote control effective range
Infra-Red (IR) remote control sensors are located on the front and the back of the projector.
The remote control must be held at an angle within 30 degrees of the projector’s IR remote control sensors to
function correctly. The distance between the remote control and the sensors should not exceed 6 meters (~
20 feet).
Make sure that there are no obstacles between the
remote control and the IR sensors on the projector
that might obstruct the infra-red beam.
Replacing the remote control battery
1. Pull out the battery holder.
2. Insert the new battery into the holder. Note:
The positive polarity should face outward.
3. Push the holder into the remote control
until it clicks into place.
λ Avoid excessive heat and humidity. There
may be battery damage if the battery is
incorrectly replaced.
λ Replace only with the same or equivalent type
battery, as recommended by the battery manufacturer.
λ Dispose of the used battery according to the manufacturer’s instructions.
λ Never throw a battery into a fire. There may be danger of an explosion.
λ If the battery is dead, or if you will not be using the remote control for a long time, remove the battery to
prevent damage to the remote control from the possibility of battery leakage.
11