Filter
Top Products
User’ Guide
51
Set static router address
Example:
CM>nat static gateway 68.5.202.1
Set NAT public Gateway IP to 68.5.202.1
CM>show nat config
NAT : Enable
WAN SETUP :
NAT public IP configuration : Manually
Static NAT public IP address : 68.5.203.15 Subnet Mask : 255.255.254.0
Static NAT public Gateway IP address : 68.5.202.1
Interfaces
¾ interface ethernet address {ip address} mask {subnet netmask}{nat-private|””}
Set ethernet interface IP address.
Set ethernet interface IP address as nat-private gateway.
Example:
CM>interface ethernet address 192.168.100.1 mask 255.255.255.224
CM>show interface ethernet
Interface Ethernet
MAC address: 0002.8A0E.ECC8
IP address 192.168.100.1 subnet-mask 255.255.255.224
Link status: link
Mode: 100Mbps, full-duplex
Example:
CM>interface ethernet address 192.168.100.1 mask 255.255.255.224 nat-private
CM>show interface ethernet
Interface Ethernet
MAC address: 0002.8A0E.E673
IP address 192.168.100.1 subnet-mask 255.255.255.224 (nat-private)
Link status: link
Mode: 100Mbps, full-duplex
¾ interface ethernet dhcp-relay {ip address|enable|disable}
Ethernet interface dhcp-relay.