Filter
Top Products
Installing an SFP 27
Model number and connector Product number Description
1000BASE-ZX CWDM
AA1419061-E6 to
AA1419068-E6
1470 nm to 1610 nm, up to 70 km
1000BASE-BX AA1419069-E6,
AA1419070-E6
Bidirectional 1310 nm and 1490 nm, up
to 10 km
1000BASE-EX AA1419071-E6 1550 nm, up to 120 km
For specifications for these SFPs, see "SFP specifications" (page 41).
Installing an SFP
Install an SFP to provide an interface between the switch and the network
cable.
Installing an SFP takes about three minutes.
WARNING
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can
injure your eyes. Never look into an optical fiber or connector port.
Always assume that fiber optic cables are connected to a light
source.
Prerequisites
•
Verify that the SFP is the correct model for your network configuration.
Procedure steps
Step Action
1
Remove the SFP from its protective packaging.
2 Grasp the SFP between your thumb and forefinger.
3
As shown in the following figure, insert the device into the slot on
the module.
Apply a light pressure to the device until it clicks and locks into
position.
CAUTION
Risk of equipment damage
SFPs are keyed to prevent incorrect insertion. If the SFP
resists pressure, do not force it; turn it over, and reinsert it.
Nortel Metro Ethernet Routing Switch 8600
Installation — SFP, XFP, and GBIC Hardware Components
NN46220-301 02.04 Standard
4.2 14 February 2008
Copyright © 2008, Nortel Networks
.